]]>
On the left is a light that says: LOW
On the right is a light that says: HIGH
In the middle it says: HEART RATE/MIN and
there is a gauge that goes from 0 to 250 in increments of 25
with hash marks between increments.
On the bottom left is an OFF ON POWER push button
To the right of that it says: ALARMS OFF
To the right of that is a lever switch with choices: ALARMS OFF ALARMS ON RESET
On the back, on the top left is the power plug port.
To the right of that is a fuse
Below that are 2 areas with ports that have computer board-like end fingers.
It says: ~ LINE
INLET 115/230V ± 10%
50-60 Hz 40 VA MAX
FUSE 115V 300 mAT
230V 150 mAT
Hewlett Packard 7803B
ECG MONITORING SCOPE
On the right you have a knob for CHANNEL 1 POSITION
Below that is a knob for CHANNEL 2 POSITION
On the bottom left is an ON OFF POWER push button
To the right of that is a switch that says: SWEEP MM/SEC and the choices are 25 and 50
On the left side of the front is the scope screen
On the back, on the bottom left are two power plug ports.
To the right of that is a fuse
To the right of that are 4 hole ports that each say: INPUT
Above that area are two male small bolts that says GAIN and the
one on the left says: CHANNEL 1 and the right one says: CHANNEL 2
Above that on the left is an switch with the choices: FREE RUN and SYNC
To the right of that is a hole port that says: SYNC INPUT
To the right of that is a knob that says: INTENSITY
The only cables that came in with this lot are 2 power cables.
One connects both units together.
The other one has a three pronged electrical plug.
We plugged it in and pressed the power button on the 7803B.
The light came on next to the power button.
Two green dots appeared on the screen causing a moving horizontal line graph that fluctuated as we moved the dials to the right.
We pressed the power button on the 7828A.
The light in the middle came on and the LOW light came on when we moved the middle alarm switch to ON. The HIGH light additionally lit up as we pressed the alarm reset switch.
That was the extent of the test.
There are a few dirt smudges and scratches.
There is a mark on the bottom face of the 7803B where a label was removed.
There are some white paint marks on one of the cables.
It will be an AS IS sale.
Logically, ANY medical equipment purchased SHOULD be completely tested by a qualified medical equipment technician prior to being put into service.
This item is sold used, as is, with no warranty expressed or implied.
The buyer will not hold the seller responsible for the appropriate or inappropriate use of this device either by the buyer, user or a third party.
It is the sole responsibility of the buyer to assume any and all liability from the use of this equipment.
plus 7.75% Ohio sales tax
You must pick it up from our location in Euclid, Ohio
Cash sale only.
